Cedima CF-2116 D - Problems with the Engine

ENGLISH
56
Trouble shooting, what if …?
• CEDIMA
®
• Technical Documentation • All rights reserved as per ISO 16016 • Subject to modications due to progressive development •
8.0 Faults/trouble shooting on the CEDIMA
®
joint cutter CF-2116 D
8.1 Problems with the engine
Problem Possible cause Remedy
Engine does not start No fuel in the tank
Speed (rpm) adjustment lever is
not in the Stop or Idle position
There is air in the fuel system
Battery is at
Re-ll with fuel
Move the lever to the start position
Bleed off the air in the fuel system
R e-charge the battery
Engine has difculty
starting
The engine oil is too thick (due
to cold weather)
The fuel (Diesel) is viscous
(tacky) and/or dirty
Oil appropriate to the time of year (change the oil)
Clean the fuel system (tank, pipes lter)
The engine has loss
of power
Insufcient fuel supply
The wrong sort of lter
Dirty engine air lter
Check the fuel pipes for leakage
Check the fuel lter for dirt
Change the fuel lter
Bleed off the fuel system
Use the correct fuel lter (original parts)
Clean or change the air lter cartridge
The engine runs too
hot
Not enough engine oil
The wrong sort of fuel
The engine is not cooling off
enough
Check the oil level and, if necessary ll up
Use the correct, recommended fuel
Check the engine air cooler grating, the air-directing
panels for dirt and stoppages. Also check the installa-
tions
ATTENTION
Pay attention to the operating manual of the engine!
For (further) troubleshooting, please also observe the operating instructions of the engine manufacturer
provided, or contact a specialised workshop.
All works on the diesel engine must only be performed by an authorized qualied work-shop or directly
by CEDIMA
®
.