Cedima CF 22 E - Accessories Provided

6
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Technical data and accessories
Equivalent total vibration rating a
hv, eq
< 2,5 m/s²
Measurement uncertainty K m/s²
The given values can vary as they depend on the application conditions (the material that has to be cut, the state of the
machine, handling, the operator and the diamond tools being used, etc.).
The actual period of exposure, which can be considerably aected by the non-productive times (reduced), must always be
taken into consideration when determining the daily vibration load A(8) as per DIN EN ISO 5349-2. The following count as
non-productive times: time needed for relling with fuel, dealing with the water supply, changing the tools, setting up and
moving the machine, etc., as well as securing the workplace, the area of operation.
Uncertainties in measurement according to DIN EN 12096.
Aparameter calculator for determining the daily vibration rating (daily vibration load A(8)) can be found on the internet
e.g. The German Accident Insurance (DGUV) and/or the Trade Association sites (BG).
DANGER
Risk of being injured when exceeding the highest permissible daily vibration load!
At uninterrupted work with the CF•22 E the daily maximum value is not reached (noise and accident prevention
regulation).
1.2 Vibration acceleration values, hand-arm vibration
1.3 Accessories provided:
1 x double open-ended spanner SW 17/36
1 x operating manual
1 x spare parts list
No liability will be accepted for any damage that results from using accessories that do not comply with the
CEDIMA®
specications.
Details for aiding in the selection of the correct diamond saw blade can be obtained in the current price list as well
as in the current joint cutter brochure
Contact CEDIMA® directly in the case of special applications.
Alist of additional accessories can be found in the current CEDIMA® price list.