30
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
8.0 Terms of warranty
1. Complaints must be submitted without delay, however, within 14 days following the arrival of the
device at the latest. If this deadline has expired, or if the device complained about is put into operation
and used for work, then the device complained about shall be considered accepted and therefore free
of faults. Hidden defects must be reported in writing immediately after being discovered, however at
the latest within 6 months of the receipt of the device.
2. We guarantee the agreed usability of the device delivered by us for a period of 12 months, the term
beginning on the day the device arrives with the buyer. Irrespective of this, our obligation shall be
considered as fullled, as soon as the goods are despatched from our works/warehouse. In no case do
we assume a producers’ guarantee. The mandatory regulations of the law for product liability remain
untouched.
3. Wearing parts are subject to a limited warranty. Wearing parts are parts subject to operationrela-
ted wear during proper use of the device. The rate of wear cannot be uniformly dened and diers
according to the intensity of use. The wearing parts must be adjusted, maintained and, if necessary,
replaced for the specic device in accordance with the manufacturer’s operating manual. Operation-
related wear is not a reason for claims to defects.
Wearing parts for the construction devices such as core drilling and sawing machines and special ma-
chinery as well as related general assemblies (if available):
– Feed and drive elements such as toothed racks,
gear wheels, pinions, spindles, spindle nuts,
spindle bearings, wires, chains, sprockets, belts
–
Seals, cables, hoses, packings, gaskets, plugs,
couplings and switches for pneumatic, hydrau-
lic, water, electricity, fuel systems
– Guide elements such as guide strips, guide
bushes, guide rails, rollers, bearings, sliding
protection supports
– Clamping elements for quick release systems
– Flushing head seals
– Slide and roller bearings that do not run in an
oil bath
– Shaft oil seals and sealing elements
– Friction and safety clutches, braking devices
– Carbon brushes, collectors/armatures
– Consumable operating materials such as fuels,
lubricants, coolants etc.
– Easy-release rings
– Control potentiometers and manual switching
elements
– Securing elements such as dowels, anchors,
screws and bolts
– Fuses and lamps
– Bowden cables
– Commutators
– Diaphragms
– Spark plugs, glow plugs
– Parts of the reversing starter such as the star-
ting rope, starting pawl, starting roller and
return spring
– Sealing brushes, rubber seals, splash protection
cloths
– Filters of all kinds
– Drive and guide wheels/pulleys and associated
rubber tyres
– Cable wire protection elements
– Drive and travel wheels
– Water pumps
– Cut-material transport rollers
– Drilling, separating and cutting tools
– Energy storage devices
Page 1 of 2 pages
To Next Page
Loading...
