Cedima CF 22 E - Basic Safety Instructions

9
• CEDIMA® • Technical Documentation • All rights reserved according to ISO 16016 • Changes serving technical progress reserved •
Basic safety instructions
for joint cutters
3.0 Basic safety instructions
ATTENTION
Read and observe all operating manuals pertaining to
the joint cutter!
3.1 Icons, symbols, notes
The following signs and symbols are used at the joint cutter
for information of special importance:
DANGER
Warning of a hazard area!
DANGER
Warning of cutting shaft, saw blade!
To move the joint cutter beyond the cutting
area, stop the tool!
Maximum
mountable saw
blade diameter!
(450 mm)
Direction of rotation of saw
blade / cutting shaft (on the saw
blade guard)
Guaranteed sound pressure
level
Read the operating manual!
Use eye protection!
Use hearing protection!
Use foot protection!
Use hand protection
Use light breathing protection
The following designations or characters are used in the
operating manual for particularly important information:
Note
Special instructions regarding economic use. The advice
that follows after the "Note" symbol contains important
information that diers from other text!
ATTENTION!
Special information regarding instructions and prohibitions
for avoiding damage. The advice that follows after the
"ATTENTION!" symbol contains instructions that must be fully
complied with in order to prevent damage occurring to the
ttings or material as well as injuries to the operator or third
parties!
DANGER
Details or regulations and prohibitions for
the prevention of injuries to personnel and/or
extensive equipment damage. The advice that follows after
the "DANGER" symbol warns you that ignoring the relevant
instructions or procedural instructions might result in the
operator or third parties being injured!
Important passages are always written in italics!
Text passages relating to safety are always shown in bold
lettering, in italics!