Cellink BIO X - Unpacking BIO X

18
3.1 Unpacking BIO X
Follow these steps to unpack BIO X.
Do not aempt to unpack BIO X without reviewing the procedure below. Doing so
risks personal injury and equipment damage.
BIO X is heavy. Always use a minimum of two people to unpack and move the BIO X.
1. Clear a steady table and oor space of at least two by three meters.
2. Place the box on its side according to the arrows on the surface.
3. Carefully remove the tape on the top of the box.
4. Use the packaging handles to remove the contents of the box and place them on the oor.
5. Li the packaging carefully to turn the BIO X so it is standing on its correct side.
6. Remove the top piece of the packaging. Grab it at the boom edge to li BIO X out of the
boom piece of packaging. Place BIO X on the table.
7. Remove any remaining packaging material from BIO X.
8. Remove the remaining contents of the box and check that you have
received all equipment listed below.
This side up during transport