Cellink BIO X - Setting Up BIO X

20
3.3 Seng up BIO X
Before connecng BIO X to a wall socket, ensure that the socket is grounded. Next, connect BIO X
to the power outlet (see 2.1 Product map) and the grounded wall socket with the included power
cable.
BIO X has an internal air supply capable of supplying 200 kPa to the printheads. To use a higher
pressure, connect an external air supply to the back of BIO X (see 2.1 Product map.)
Turn on BIO using the power switch on the back (see 2.1 Product map.)
Ensure that the external air supply does not exceed the specicaons outlined in
Chapter 2.2, Technical specicaons. Improper use can use equipment damage and
personal injury.
Always connect BIO X to a grounded outlet. Connecng to an ungrounded outlet can
cause equipment damage and personal injury.