Cellink BIO X - General Safety Information

6
Review the enre manual, as well as the manuals for any accessories, before you start using BIO X.
Mishandling can lead to equipment damage and serious injury. The following symbols are used to
indicate risk of equipment damage or personal injury:
CELLINK AB
Arvid Wallgrens Backe 20
Gothenburg, SE 41346
Sweden
1.1 General safety informaon
If BIO X acts in a way that is not described by this manual, turn it o and contact CELLINK.
Use BIO X for its intended purposes only. Do not modify its instruments, subcomponents or
accessories. Do not open BIO X, disassemble BIO X or aempt any service other than the instrucons
described in the manual.
This symbol indicates presence of UV light. Keep the BIO X door closed and wear
proper safety are during UV sterilizaon and UV curing. This symbol appears on the
touchscreen when a UV light source is acve.
Never place your ngers near the machine unl all parts have stopped moving. Moving
parts can cause injury.
This symbol indicates risk of injury or equipment damage.
Never clean or service BIO X while the machine is on. Always turn o the power and
disconnect any external sources of power and air pressure before cleaning or servicing
BIO X.
This symbol indicates a heated surface. BIO X has heated surfaces that may cause
personal injury or equipment damage if not treated with care. A physical symbol labels
these surfaces on the BIO X, and the symbol appears on the BIO X touchscreen when
the print chamber is heated.
Manufacturer