Cellink BIO X - Page 47

47
4.4.5 Printhead movement test
Use this tab before prinng to test printhead movement along the X, Y and Z axes.
4
5
6
1 2 3
1. Printhead 1 - Test movement for printhead 1.
2. Printhead 2 - Test movement for printhead 2.
3. Printhead 3 - Test movement for printhead 3.
4. Z axis command - Controls the posion of the printbed along the Z axis.
5. X, Y axis command - Controls the posion of the printeads and the surface along the X and Y
axis.
6. Home command - Home the printer.