Cembre MG4 - FCC Certifications and Wireless Functionality; Service and Overhaul Information; Return for Overhaul and Service Procedures

23
Certications10
Return to CEMBRE for overhaul11
In the case of a breakdown, contact our Area Agent who will advise you on the problem and give you the necessary
instructionsonhowtodispatchthetooltoournearestserviceCentre;ifpossible,attachacopyoftheTestCerticate
suppliedbyCEMBREtogetherwiththetoolorllinandattachtheformavailableinthe“ASSISTANCE”sectionof
the CEMBRE website.
FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interferencewillnotoccurinaspecicinstallation.Ifthisequipmentdoescauseharmfulinterferencetoradioortelevi-
sionreception,whichcanbedeterminedbyturningtheequipmento󰀨andon,theuserisencouragedtotrytocorrect
the interference by one or more of the following measures:
- Reorient or reposition the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connecttheequipmentintoanoutletonacircuitdi󰀨erentfromthattowhichthereceiverisconnected.
- Consult the retailer or an experienced radio/TV technician for help.
Anychangesormodicationsnotexpresslyapprovedbythepartyresponsibleforcompliancemayvoidtheuser's
right to use this equipment.
Wireless functionality
TheequipmentcontainstheFCC,IC,ETSI/CEcertiedwirelessmoduleandindicatedbelow:
manufacturer: Texas Instruments
type: WL1831MOD
FCC ID: Z64-WL18SBMOD
IC: 451I-WL18SBMOD
MICcerticatenumber:201-135370