Centurion R3 - Page 22

ACTIONCAUSESYMPTOM

Check that the RED LED's
adjacent each trigger input
on the controller (TRG, FRX,
PED) are OFF and only
switch ON when that input is
activated.

Consult your installer.

Check that the fault only
oc cur s with one of the
transmitters. Replace the
battery.

Receiver must be mounted in
an elevated position, housed
in a we ather proof, non
ferrous enclosure.

Make sure that the aerial is
straight.

Consult your installer.

Check for corrosion of the
wire terminations behind the
key-switch. Consult your
installer should the problem
persist.

Replace fuse - 220V 3A fast
blow. Size 5x20mm.
CAUTION - 220V, make
sure supply to system is
isolated

Check that the lamp load
does not exceed 500W.

Check the bulb and replace if
necessary. Make sure that
the bulb is making good
electrical contact in its
holder.

Consult your installer should
the problem persist.

Gate opens on its own.

Radio transmitter has poor
range.

Master gate opens to pedes-
trian and closes.

Courtesy light does not oper-
ate.

Permanent input on one of
the tr igg er l ine s to the
controller.

Transmitter battery flat.

K e y - s w i t c h u s e d f o r
activating pedestrian facility
is faulty - where applicable.

Light fuse blown.

Faulty trigger line cables.

R a d i o r e c e i v e r c a n n o t
receive transmitter signal
properly.
Consult your installer if the
problem persists.

Make sure that nobody has
accidently used the origin
adjustment tool to release
the manual override. Consult
your installer should this be
suspected.

Origin position has been
shifted.
Page 22