Centurion SDO4 SMART - Preparation of Site; General Considerations for the Installation

page 13 www.centsys.com
5.1. General Considerations for the Installation
Always recommend the tment of additional safety equipment such as safety edges
and safety beams, for additional protection against entrapment or other mechanical
risks.
Ensure that no pipes or electrical cables are in the way of the intended installation.
Install the garage operator only if:
• It will not pose a hazard to the public
• The installation will meet all municipal and/or local authority requirements once
completed
• The door mass and application is within the operator specications
• There is a properly-earthed general purpose 220-240V AC power outlet that has been
installed by a qualied electrical contractor
• All locks, ropes and / or securing mechanisms have been removed
• The ceiling structure is adequate enough to support the weight of the SDO4 SMART
• The garage door is in good working order, meaning:
• it opens freely;
• it is well-balanced;
,
• it does not move on its own if left in any position for more than 100mm;
• it can be installed to have sucient clearance between moving parts when
opening or closing to reduce the risk of personal injury and / or entrapment
Any repairs to the garage door that need to be done due to any of the above
requirements not being in place, must be carried out by technically qualied
persons.
Attempting to repair the garage door without suitable technical
qualications, may result in severe personal injury, death, and / or
property damage.
An improperly-balanced or malfunctioning garage door could cause
serious personal injury, death and / or property damage.
Have a qualied person check and, if required, make repairs to the
garage door before installing the SDO4 SMART.
PREPARATION OF SITESECTION 5
5. Preparation of Site