page 6
3. Features and functions
FIGURE 4
Introduction
The VECTOR2 linear arm operator is controlled with the VECTOR2
controller (PCA10501Vx). The controller synchronizes the functions of the
gate operator.
The VECTOR2 controller is particularly user-friendly as it is fitted with a
LCD (Liquid Crystal Display) that provides useful information on the
status of the system.
Under normal running conditions the ‘User Display’ is shown on the LCD
display. (A ‘Debug Display’ can be invoked and is typically used by the
installer where abnormal operational problems occur)
3.1. Gate operation
3.1.1. Full gate opening
The CENTURION rolling code
TM
(Keeloq encryption) remote
controls that operate with the
onboard receivers of the
VECTOR2 swing gate operator
are used to operate the gate.
However, most automatic gate
installations are also fitted with
an intercom, which provides for
communication between the
house/building and the gate.
The handset is usually fitted
with a gate/door release
pushbutton which, when
pressed, will operate the gate.
FIGURE 5
Features
and
functions
To Next Page
Loading...
