4-38
47 WAITING FOR NODE
Condition for error detection
Failure of the can bus comunication. The alarm appears if the lifting logic unit receives the information of
I/O card ether traction logic unit or armrest board with a delay.
• Check if the alarm appears in combination with other alarms. In this case, this alarm is consequent.
• Check the dashboard’s alarms, before replacing any cards
• If the alarm appears alone:
• Check the can bus connector: all wires must be well connected in both the side of the wiring harness.
The alarm can be generated by a false contact
• if the above tests are negative replace the lifting logic unit
48 AUX OUTPUT KO - UNUSED
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
