0-19
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
PERIODIC MAINTENANCE
Periodic inspection and maintenance are necessary to keep your forklift truck running smoothly, and must
be performed by specialized technicians: ask your Dealer Service Centre.
Maintenance intervals are based on total operating hours, or months of truck life cycle, whichever comes
first (i.e. most inspections are scheduled every 1000 operating hours, or at least every six months).
Trucks operating under multi-shift work conditions must reduce intervals by:
15% for 2 daily shifts
30% for 3 daily shifts
INSPECTION METHOD:
I: Inspect, correct and replace as required
M: Measure and correct, and adjust as required
T: Tighten
C: Clean
(*) New trucks: weekly / 40h inspections are referred to new trucks only (whether under multi-shifts or not)
PERIODIC REPLACEMENT TABLE
REPLACEMENT CYCLE
(Based on total operating hours or months of truck life
cycle, whichever comes first)
every 1 week 12 30 60 months
every 40 2000 5000 10000 hours
Drive unit oil
*
Hydraulic oil
Hydraulic filter
*
Oil tank breather filter
Brake fluid
Service brake and parking brake hoses
Tilt cylinder hydraulic hoses
Steering system hoses
Lifting chains
Chain securing tie rods
High pressure hydraulic hoses
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
