Cessna T188C - Page 302

7. Fill tanks
to capacity, apply
electrical power as required
and verify that
the fuel quantity indicators
indicate "FULL".
A. If "FULL"
is not indicated, adjust, troubleshoot, repair
and/or replace fuel indicating components
as
required until the "FULL" indication is achieved.
NOTE: Stewart
Warner fuel quantity indicating systems
can be adjusted. Refer to this section
for
instructions for adjusting
Stewart Warner fuel indicating
systems.
Rochester
fuel quantity indicating system
components are not adjustable, only
component
replacement
or standard
electrical wiring system
maintenance
practices are permitted.
8. Install any
items and/or equipment removed to accomplish
this procedure, remove maintenance
warning tags and
connect the airplane
battery.
Temporary Revision Number 4
2D
© 2002 Cessna Aircraft Company
7 October 2002
15-12D