CLEANING & STORAGE
200
according to periodic maintenance chart�
Tie plastic bags over the mufer exhaust pipe to prevent moisture from entering.
Put a cover over the motorcycle to keep dust and dirt from collecting on it�
Preparation After Storage
Remove the plastic bags from the mufer.
Verify the battery condition� Charge it if necessary, then install the battery in the motorcycle�
Lubricate any pivot points as necessary (handle bar levers, foot pedal, etc)�
Check all the points listed in Pre-Ride Inspection section�
Test ride at slow speed to verify the vehicle functions normally�
Transporting Your Vehicle
If your vehicle needs to be transported, it should be carried on a motorcycle trailer, a atbed truck, or trailer
that has a loading ramp or lifting platform, and be secured with motorcycle tie-down straps� Never try to
tow your vehicle with a wheel or wheels on the ground�
To Next Page
Loading...
