48
CONTROLS & FEATURES
Center Stand
(If equipped) The center stand, located at base of the frame, is
for parking the vehicle�
Adjust the position adjusting block to keep a safe distance
shown between center stand and chain to prevent the stand
from contacting the chain during driving�
WARNING
Too close of distance between center stand and chain will
lead to component wear, which can aect driving stability and
safety, which could cause a serious safety incident� Inspect
the distance between the center stand and chain, and adjust
periodically as necessary�
Center Stand to Chain Distance Measurement:
Pull chain down to the limit and check center stand and chain
distance, which should be larger than 8mm� If less than 8mm,
inspect chain wear, chain tightness (for details refer to Drive
Chain Inspection) and center stand position�
Inspect distance between center stand and chain every 1000km�
Adjust or replace as necessary�
＞8mm
To Next Page
Loading...
