-10-
NOTICE
Make sure that the cross-sectional area of charging cables is 25 to 35
mm2.
A breaker between the Product and inverter is recommended to install, and
the breaker’s min. current should be over 150A or following with local
regulations.
4.4 Tools
To install the battery pack, the following tools are probably required:
In order to protect operator and installer’s safety, please select and use suitable
tools and measuring instruments that are properly certified.
4.5 Safety instruments
When dealing with the Product, the following safety gears should be equipped.
Installers must meet the relevant requirements of IEC 60364 or the domestic legislation
and other relevant international standards.
Insulated glove
Safety goggles
Safety shoes
-
To Next Page
Loading...
