-13-
5.3.1 Connect with 51.2Vdc Inverter
To prevent the battery from moving, make sure the battery is fixed to a wall.
NOTICE
If the battery is installed above the floor or on a platform, make sure that
the wall or platform is capable of supporting the battery’s weight.
5.3.1.1 Wall Mounting
1. Use the Positioning cardboard to
determine the bracket mounting
place.
2. Drill holes in the wall for the M8
expansion screw anchors, which
depth should be at least 50 mm.
Tighten the screws to a torque around
2.5 N∙m.
3. Fasten the battery to bracket fasten
hole with M6 screws with 2.0N ∙ m
roughly.
4. Meanwhile, two or four batteries could
be installed by these brackets.
Note: if more than 4 batteries are installed, a cabinet is recommended to be selected
for the battery’s stable.
To Next Page
Loading...
