CH M10 - Shortcut Menu; Network Menu

M10 User Manual 21
3.5.4 Shortcut menu
The M10 allows you to establish up to six shortcuts, taking you directly to almost any parameter in any menu.
The M10 has no pre-programmed shortcut. After scrolling through the latest shortcut, the next screen that the
M10 display is the entry port to the M10 menu. It reads Detailed Setup.
3.5.5 Network menu
Status
Shows a list of compatible devices detected on the LAN.
Role
When physically connected to a network, the M10 can ignore this network (ofine) or connect to it as either
the master unit (it will transmit push-button commands to all compatible client units) or as a client (it will
ignore push-button entries and receive commands only from the master device). This networking facility
allows system-wide sharing of commands among CH products (such as mute or power up/down).
Room number
Denes the room in which the M10 is located for multi-room applications.
This prevents CH Precision units connected to the same network but located in different systems/rooms to
interact with each others.
IP settings
Auto should be selected if the M10 is connected to a router with DHCP server feature. More advanced
settings are available if needed.
Wake-on-LAN
If No is selected, the M10 can’t be woken up by the app. Standby mode will consume less than 0.5W.
When Only if PoE is selected, the M10 can only be woken by the app if connected to a Power-over-
Ethernet switch. Standby mode will draw less than 0.5W from the mains plug.
If Yes is selected, the M10 can always be woken up by the app. Standby mode will draw less than a couple of
watts from the mains plug.
Power off command
If Yes is selected, the M10 will enter standby mode when it receives a Power Off command from the LAN.
It will remain on if No is selected. This is useful if you want to keep your M10 on even when you turn off the
rest of your system.
Network knowledge
The M10 keeps track of all discovered devices, in order to turn them on if it is set as a Power Master. If the
audio system evolves, the list of devices can be cleared by this function.