125
GB
table of error codes
ERROR DESCRIPTION
3 04 Too many resets
3 05 PCB Fault
3 06 PCB Fault
3 07 PCB Fault
3 08 ATM confi g error
3 09 Gas Relais check Failed
3 11 Boiler error
3 12 Boiler error
3 P9 Sched.Maintanace-Call Service
4 01 Mdm-Bus Com err
4 02 GPRS mdm error
4 03 Sim Card error
4 04 Mdm-PCB Com err
4 05 Mdm In1 error
4 06 Mdm In2 error
4 11 Room Sensor not available Z1
4 12 Room Sensor not available Z2
4 13 Room Sensor not available Z3
4 14 Room Sensor not available Z4
4 15 Room Sensor not available Z5
4 16 Room Sensor not available Z6
4 20 Bus supply overload
4 21 Boiler error
4 22 Boiler error
4 30 MF Function not defi ned
4 31 MF Temp sensor 1 damaged
4 32 MF Temp sensor 2 damaged
4 33 MF Temp sensor 3 damaged
4 34 MF error
4 35 MF error
5 01 No fl ame detected
5 02 Flame Sensed with Gas Valve Closed
5 04 Flame lift
ERROR DESCRIPTION
5 10 Boiler error
5 11 Boiler error
5 P1 1st Ignit Failed
5 P2 2nd Ignition Failed
5 P3 Flame lift
5 P4 Flame lift
6 01 Fumes Overfl ow
6 02 Fumes Overfl ow
6 04 Low fan speed
6 07 APS on FAN off
6 08 APS off FAN on
6 10 Exchanger Probe Open Circuit
6 12 Fan Error
6 20 Boiler error
6 21 Boiler error
6 P1 APS late closing
6 P2 APS close-open
6 P4 Low fan speed
7 01 Zone1 Send Probe Damaged
7 02 Zone2 Send Probe Damaged
7 03 Zone3 Send Probe Damaged
7 04 Zone4 Send Probe Damaged
7 05 Zone5 Send Probe Damaged
7 06 Zone6 Send Probe Damaged
7 11 Zone1 Return Probe Damaged
7 12 Zone2 Return Probe Damaged
7 13 Zone3 Return Probe Damaged
7 14 Zone4 Return Probe Damaged
7 15 Zone5 Return Probe Damaged
7 16 Zone6 Return Probe Damaged
7 22 Zone2 Overheat
7 23 Zone3 Overheat
7 25 Zone5 Overheat
To Next Page
Loading...
Need help?
General
