Safety
01-6 79032966 A Rev.
FIG. 18: Do not remove radiator cap if engine is hot.
Only remove the cap when the cap is cool enough to
touch with bare hands. Loosen cap slowly to first notch to
relieve pressure, then remove cap.
FIG. 19: Remove any spilled oil, antifreeze, or fuel
immediately from operator ladder and platform and other
access areas.
Keep all access areas clean and free of obstructions.
FIG. 20: Never permit any flame cutting, welding, or arc
welding to be done on or near the sound proofing
upholstery used in the cab. This material is flame resistant
to normal exposure to cigarettes or other smoking
material. But will ignite and sustain combustion when
exposed to the heat of gas or electrical welding. The build
up of chaff and crop debris in the engine compartment, on
the engine, and near moving parts is a fire hazard. Check
and clean these areas frequently.
FIG. 21: Always stop the combine engine before fueling.
Do not smoke while fueling.
FIG. 18
Wc1951
FIG. 19
Wc1939
FIG. 20
Wc1946
FIG. 21
Wc1959
To Next Page
Loading...