Machine specifications MT900E
Rear axle: 9C, permanently lubricated U-joint, and
greasable support bearing
Articulation: 9C, permanently lubricated U-joint, and
greasable slip joint
Engine block heater Warms engine coolant to make cold weather starts
easier, 120 volt or 240 volt
Drawbar capacity
The vertical weight capacity of the drawbar is dependent on the category.
Distance from PTO shaft to the
hold for the drawbar pin
Maximum down force
Category IV 500 mm (19.7 in) 4536 kg (10 000 lb)
Category V 500 mm (19.7 in) 5670 kg (12 500 lb)
NOTE:
Drawbar can be permitted to swing or can be in a fixed position.
Tire size Rolling circumference mm (in)
480/80 R46 5842 mm (230 in)
520/85 R42
710/70 R38
480/80 R50 6172 mm (243 in)
520/85 R46
620/70 R46
650/85 R38
710/70 R42
800/70 R38
1100/45 R46 6375 mm (251 in)
1.8.2 Shipping weights MT900E
Weight chart
Configuration Shipping Estimated operating axle weight
percentages
kg (mass) lb front rear
Standard 18 400 40 530 61 39
With front counter
weight bracket
18 900 41 650 63 37
With front counter
weight GP 20
weights
19 800 43 670 68 32
GUID-9378548C-D3F7-4CF0-817B-BAC978AD52CB [V1]
1. General
1-32 Articulated Tractor
79036231D
To Next Page
Loading...
