Chamberlain 374UT - Getting Started

2
GETTING STARTED
The Universal Mini Remote Control can be programmed to activate up to two products, such as a garage door opener, MyQ
®
light
control, gate operator, or commercial door operator. Each button on the remote control works independently of the other and must
be programmed separately. The images throughout this manual are for reference only and your product may look different.
Bottom Button
Garage Door Opener
Commercial Door OperatorGate Operator
LED
You will need to locate the Program/LEARN button on your product before you start programming.
GARAGE DOOR OPENERS
TheProgram/LEARNbuttonistypicallylocatedonthebackorsidepanel
ofyourgaragedooropener.YourProgram/LEARNbuttonmayhavea
differentname(SMARTbutton,SETbutton,etc.).Forhelplocatingyour
Program/LEARNbuttonrefertotheTableofContentsinthismanualor
contactyourgaragedooropenermanufacturer.
COMMERCIAL DOOR OPERATORS
TheRADIObuttonistypicallylocatedonthelogicboardofyouroperator.
ForhelplocatingyourRADIObuttoncontactyourdooroperator
manufacturer.
GATE OPERATORS
TheProgram/LEARNbuttonistypicallylocatedonthecontrolboardof
youroperator.YourProgram/LEARNbuttonmayhaveadifferentname
(RADIObutton,XMITTERbutton,etc.).ForhelplocatingyourProgram/
LEARNbuttoncontactyourgateoperatormanufacturer.
EXTERNAL RECEIVER
Someproductsdonot
haveaProgram/LEARN
button.Inthiscase,the
Program/LEARNbutton
willbelocatedinan
externalreceiver.The
receiverwillbelocatedon
theproductormounted
nearby.Followthe
programminginstructions
foranexternalreceiver.