Chamberlain 374UT User Manual

8
GARAGE DOOR OPENERS
Programming to a Garage Door Opener with a Program/LEARN Button
The Program/LEARN button is typically located on the back or side panel of the garage door opener or an external receiver. For
help locating your Program/LEARN button contact your garage door opener manufacturer.
If you have a LiftMaster or Chamberlain branded garage door opener with a yellow learn button, press and release the learn
button, then press and hold the button on the remote control you would like to use. If programming is not successful, proceed
through the steps below.
If you have a Genie
®
Intellicode
®
2 garage door opener go to the next page.
Theimagesthroughoutthismanualareforreferenceonlyandyourproductmaylookdifferent.
BottomButton
1
Startwithyourgaragedoorclosed.
2
Pressandholdbottombuttonontheremotecontroluntil
theblueLEDstayssolid(approximately15seconds)then
releasethebutton.
3
PressandreleasetheProgram/LEARNbuttononyour
garagedooropener.
4
Ontheremotecontrol,pressandreleasethebuttonthat
youwouldliketoprogramtwice.TheblueLEDwillblink
forupto60seconds.
5 6
Waitforthegaragedoortomove,thenpressandrelease
eitherofthebuttonsontheremote.
LED
Testtheremotecontrolbypressingthebuttonyou
programmedinstep4.Ifthegaragedooropenerdoesnot
activate,repeattheprogrammingsteps.
IMPORTANT: The remote will activate your garage door during
programming. Ensure garage door is clear of ALL obstructions.
LED

Chamberlain 374UT Specifications

General

Brand	Chamberlain
Model	374UT
Category	Remote Control
Language	English