11
1. Mount the CAPXS Mounting Bracket securely to a flat surface or
pedestal with appropriate (1/4 in.) flat head hardware for Surface
Mount or appropriate #6 Flat Head screw for Gang Box Mount.
Stainless steel hardware is recommended for mounting.
NOTES:
-ADA Compliance: When mounting the CAPXS at a pedestrian entrance, to
meet ADA compliance, mount the top of the CAPXS screen no higher than 54 inches from the ground.
Install Mounting Bracket
1
DO
Make sure the CAPXS is properly sealed to
prevent damage to the CAPXS from moisture.
For rough surfaces such as brick, additional
sealing will be needed.
ACCOUNT SETUP NETWORK/MOUNTINGPOWER ACCESS CONTROLINTRODUCTION
INTRODUCTION ACCOUNT SETUP NETWORK/MOUNTINGPOWER ACCESS CONTROL
INTRODUCTION ACCOUNT SETUP NETWORK/MOUNTINGPOWER ACCESS CONTROL
INTRODUCTION ACCOUNT SETUP NETWORK/MOUNTINGPOWER ACCESS CONTROL
INTRODUCTION ACCOUNT SETUP NETWORK/MOUNTINGPOWER ACCESS CONTROL
Surface Mount Gang Box Mount
OR
To Next Page
Loading...
