Chamberlain ELITE Series User Guide

Programming
Remote Control
Below are the steps to program a new or existing remote control.
Test remote control before reprogramming.
1. Press and release the LEARN Button on the
garage door opener.
2. Press and hold the button on the remote
control that you wish to use. Release the
button when the garage door opener lights
blink or two clicks are heard.
OR
Select Menu > Program > Remote and follow the on
screen prompts.
If your vehicle is equipped with a Homelink
®
, you may
require an external adapter depending on the make,
model, and year of your vehicle.
Visit www.homelink.com for additional information.
Wireless Keyless Entry
Refer to the instructions provided with your keyless entry OR go
to LiftMaster.com to download instructions.
To Erase the Memory
LEARN
Button
Erase ALL Remote Controls and
Keyless Entries
Press and hold the LEARN button
until the LED goes out (approximately
6 seconds).
All remote controls and keyless entries are now erased.
Erase ALL Devices (Including myQ
®
enabled accessories)
1. Press and hold the LEARN button until the LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button until the LED
goes out. All codes are now erased.
Adjustment
Button
Erase the Wi-Fi Network from
the Garage Door Opener
Press and hold the adjustment
button until 3 beeps are heard
(approximately 6 seconds).
7

Chamberlain ELITE Series Specifications

General

Battery Backup	Yes
Motor Type	DC
Power Supply	120V AC
Remote Control	Yes
Max Gate Length	20 feet
Smart Home Compatibility	Yes (MyQ compatible)
Maximum Gate Width	20 feet