8
MANUAL OPERATION
1. To disengage, pull the chain and secure in the disen-
gaged position by slipping the end through the keyhole
bracket mounted on the operator.
2. The door may now be pushed up or pulled down
manually. Release the disconnect chain to operate the
door again electrically. Refer to figure 4.
FIGURE 4
INSTALL THE LIGHT AND THE LENS
Install the light
Loosen thumb screws and remove.
Rotate Lens upward.
Install the 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for approximately
4-1/2 minutes when power is connected. Then the
light will turn OFF.
Replace thumb screws.
If the bulb burns out prematurely due to vibration,
replace with a standard-neck “Garage Door Opener”
bulb.
75 WATT LIGHT BULB
THUMB SCREW
To prevent possible SERIOUS INJURY or DEATH
from a falling garage door:
- If possible, use emergency release handle to
disengage operator ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVER use emergency release handle unless
garage doorway is clear of persons and
obstructions.
WARNING
To Next Page
Loading...
