31
Operation
Connect With Your Smartphone
The Wi-Fi
®
Garage Door Opener is compatible with up to 16 myQ
®
enabled accessories. Up to 10 devices can be paired
to the Wi-Fi
®
garage door opener’s internal gateway. These devices can be controlled with the myQ
®
App. These devices
include any combination of myQ
®
garage door openers, Wi-Fi
®
garage door openers, myQ
®
light controls, myQ
®
gate
operators or myQ
®
commercial door operators. An Internet Gateway (828LM) can be added if you need to control more
than 10 devices using the myQ
®
App. Up to 6 devices can be paired to garage door opener itself (controlled by garage
door opener through 900MHz). These devices include any combination of myQ
®
light controls or a garage door and
gate monitor.
You will need:
• Wi-Fi
®
enabled smartphone, tablet or laptop
• Broadband Internet Connection
• Wi-Fi
®
signal in the garage (2.4 Ghz, 802.11b/g/n required), see page 5.
• Password for your home network (router's main account, not guest network)
• myQ
®
serial number located on the garage door opener
DOWNLOAD THE myQ
®
APP TO SET UP AN
ACCOUNT AND CONNECT
Open and close your door, get alerts and set
schedules from anywhere. Connected smart
garage door openers also receive software updates
to ensure the opener has the latest operational
features.
1. Download the myQ
®
App.
2. Set up an account and connect.
For more information on connecting your garage
door opener, visit Chamberlain.com/Customer-
Support.
NOTE: The light must be programmed to the
operator for the Timer To Close or myQ
®
app to be
able to close the door unattended.
Wi-Fi
®
Status
LED Definition
Blue Off - Wi-Fi
®
is not turned on.
Blinking - Garage door opener is in Wi-Fi
®
learn
mode.
Solid - Mobile device connected to the garage
door opener.
Blue and Green Blinking - Attempting to connect to router.
Green Blinking - Attempting to connect to the Internet
server.
Solid - Wi-Fi
®
has been set up and garage door
opener is connected to the Internet.
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until the garage door opener activates
(it may take up to 3 presses). The garage door opener must run through a complete cycle before it will activate Wi-Fi
®
programming.
An LED on the
garage door opener
will indicate Wi-Fi
status. See table
above.
LED
Learn
Button
NOTES:
The myQ
®
App WILL NOT work if the garage door
opener is operating on battery power.
If you need help adding devices to your
myQ
®
account, or to learn more go to
Chamberlain.com/Customer-Support.
To Next Page
Loading...
