Chamberlain RSL12VDC - Safety; Table of Contents; Safety Symbol and Signal Word Review

1
SAFETY
MECHANICAL
ELECTRICAL
SAFETY SYMBOL AND SIGNAL WORD REVIEW
When you see these Safety Symbols and Signal Words on the following pages, they will alert
you to the possibility of Serious Injury or Death if you do not comply with the warnings that
accompany them. The hazard may come from something mechanical or from electric shock.
Read the warnings carefully.
When you see this Signal Word on the following pages, it will alert you to the possibility of
damage to your gate and/or the gate operator if you do not comply with the cautionary
statements that accompany it. Read them carefully.
IMPORTANT NOTE:
• BEFORE attempting to install, operate or maintain the operator, you must read and fully
understand this manual and follow all safety instructions.
• DO NOT attempt repair or service of your gate operator unless you are an Authorized
Service Technician.
TABLE OF CONTENTS
SAFETY 1
SAFETY SYMBOL AND SIGNAL WORD REVIEW ..................................1
USAGE CLASS .......................................................................................2
UL325 ENTRAPMENT PROTECTION REQUIREMENTS ..........................2
SAFETY INSTALLATION INFORMATION ................................................3
GATE CONSTRUCTION INFORMATION ..................................................4
INTRODUCTION 5
CARTON INVENTORY ............................................................................5
OPERATOR SPECIFICATIONS ................................................................6
SITE PREPARATION ..............................................................................7
OVERVIEW OF TYPICAL INSTALLATION ...............................................8
INSTALLATION 9
IMPORTANT SAFETY INFORMATION ....................................................9
DETERMINE LOCATION FOR CONCRETE PAD AND OPERATOR ...........9
CONCRETE PAD AND OPERATOR ATTACHMENT ...............................10
ATTACH THE CHAIN ............................................................................10
INSTALL ENTRAPMENT PROTECTION ................................................11
POWER WIRING ..................................................................................13
DUAL GATES ONLY .............................................................................15
INSTALL THE COVER ...........................................................................17
ADJUSTMENT 18
LIMIT AND FORCE ADJUSTMENT .......................................................18
PROGRAMMING 20
REMOTE CONTROLS (NOT PROVIDED) ..............................................20
LIFTMASTER INTERNET GATEWAY
(NOT PROVIDED) .................................................................................21
ERASE ALL CODES ..............................................................................21
ERASE LIMITS .....................................................................................21
TO REMOVE AND ERASE MONITORED ENTRAPMENT PROTECTION
DEVICES ..............................................................................................21
OPERATION 22
CONTROL BOARD OVERVIEW .............................................................22
RESET SWITCH ...................................................................................23
MANUAL DISCONNECT .......................................................................23
OPERATOR ALARM .............................................................................23
REMOTE CONTROL .............................................................................23
ACCESSORY WIRING 24
EXTERNAL CONTROL DEVICES ...........................................................24
VEHICLE DETECTION DEVICES ...........................................................24
LOCKS .................................................................................................25
MISCELLANEOUS WIRING ..................................................................25
MAINTENANCE 26
IMPORTANT SAFETY INFORMATION ..................................................26
MAINTENANCE CHART ........................................................................26
BATTERIES ..........................................................................................26
DRIVE CHAIN .......................................................................................26
TROUBLESHOOTING 27
ERROR CODES ....................................................................................27
CONTROL BOARD LEDS ......................................................................30
TROUBLESHOOTING CHART ...............................................................31
APPENDIX 34
TYPES OF INSTALLATIONS .................................................................34
DETERMINE LOCATION FOR CONCRETE PAD AND OPERATOR .........35
ATTACH THE CHAIN ............................................................................35
DUAL GATE SETTINGS ........................................................................40
LIMIT SETUP WITH A REMOTE CONTROL ..........................................41
WIRING DIAGRAM 42
REPAIR PARTS 43
ACCESSORIES 45
WARRANTY 47