EasyManuals Logo

Chamberlain Whisper Drive Security+ HD900D User Manual

Chamberlain Whisper Drive Security+ HD900D
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
*3-Button Remotes
(315 MHz)
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional
buttons on any Security
®
3-Button remote or
compact remote can be
programmed to operate
other Security
®
garage
door openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the purple “learn” button on
motor unit until the learn indicator light goes
out (approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
* that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE SMART CONTROL PANEL™
1. Press the Prog <Learn> button on the
Smart Control Panel™.
2. Press the Prog <Learn> button again to
confirm Learn Mode.
3. Press the button on the hand-held
remote
* that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
NOTICE: If this Security
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security
®
remote controls.
PROGRAMMING
L
i
f
t
M
a
s
t
e
r
L
i
f
t
M
a
s
t
e
r
38

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chamberlain Whisper Drive Security+ HD900D and is the answer not in the manual?

Chamberlain Whisper Drive Security+ HD900D Specifications

General IconGeneral
Horsepower1/2 HP
Drive SystemBelt Drive
Security FeaturesSecurity+ 2.0
Remote ControlYes
Smartphone ControlYes
Motor TypeDC Motor
SecuritySecurity+ 2.0
Battery BackupNo
Wi-Fi CapableYes
Max Door Height7 ft
Max Door Weight350 lbs
LightingYes
WarrantyLifetime Motor Warranty

Related product manuals