monitoring within the app by tapping the magnifying glass
icon from the brine tank settings dialog. Tapping the icon
button under the “Enable Monitoring” will explain the steps
to setup the widget. You can decide whether to include a
valve by toggling the option under “Include Softener”. This
must be done for each valve you want to monitor.
Note:
If no softeners have been included, then “No Softeners Detected” will be displayed. However, once you have en-
abled monitoring and included the softener to be monitored, then it will update when the next scan occurs. Also,
if the softener being monitored is not in Bluetooth range during the last scheduled scan, the widget will say “No
Softeners Detected”.
Troubleshooting
If the salt level in the tank is not tracking with the salt level reported in the app, then there is most likely a problem
tank properly. This could be the screen under the injector cover is plugged or the brine line flow control is fouled.
It could also not be properly drawing the water out of the brine tank, but this would probably be indicated by an
unusually high-water level in the brine tank. The injector could also need cleaned. If there is less salt than expect-
damaged or missing.
Once setup, the widget will trigger a Bluetooth scan
every 30 minutes, as mentioned above. If all softeners
display “Salt Level OK”. If a softener is reporting that
it has low salt, then “Salt Level Low” will be displayed.
Once you add more salt to your brine tank and adjust
-
ping this widget will also open the app.
A
14
Chandler Systems
14
To Next Page
Loading...