All Rights Reserved
Figure.9-6
(1) Material stack list: Display all material stack that the work file contained;
(2) Add: Add a new one to the end of the list; tape packaged material use ID 1 to 29,
bulk IC use ID 60 to 79, IC tray use ID 80 to 99(see details below);
(3) Insert: Insert a new one to the position that before current selected material stack;
(4) Delete: Delete selected material stack, note, all of components that use this
material stack in the component list will be deleted too;
(5) Edit: Edit selected material stack, screen show as below.
Figure.9-7
To Next Page
Loading...
Need help?
General
