COMBO LOWER SUB ASSEMBLY
G16-0020-SP MOB2 STIM PCBA
G16-0030-SP MOB2 ULTRASOUND PCBA
14-1001-SP MOB2 US-STIM RIBBON CABLE
G16-2011-SP MOB2 PCB METAL SPACER 18 MM M3 X 5
G16-2061-SP MOB2 PCBA WASHER 1.6 MM x4
Handle the PCBA carefully. Beware of not scratching the connectors and the electronic components (on
the 2 sides of the PCB) around the screw holes.
Disconnect the stim board
Unscrew the board (4 x Torx T10)
Remove the board in 2 steps to disconnect properly the connector on the connector board
Unscrew the 4 metal spacers
Remove the board in 2 steps to disconnect properly the connector on the connector board
To Next Page
Loading...
