10
ILS Command User Manual Rev. 1
Operation
Effect Type
To enable or disable effect types, do the following:
1. Press the <X> encoder to access the menu.
2. Turn the <X> encoder left or right to select Effect Type.
3. Press the <X> encoder.
4. Turn the <X> encoder left or right to select from Spots, Par, Laser, Strobe effect, Derby, or GO
BACK (to return to the main level).
5. Press the <X> encoder.
6. Select from ON or OFF.
7. Press the <X> encoder.
Blinder Mode
To set whether the <BLINDER> button will toggle the blinders or activate them only while the button is
pressed, follow the instructions below.
1. Press the <X> encoder to access the menu.
2. Turn the <X> encoder left or right to select Blinder.
3. Press the <X> encoder.
4. Turn the <X> encoder left or right to select from MOMENTARY (blinders on while button is
pressed) or LATCH (button toggles blinders).
5. Press the <X> encoder.
Strobe Mode
To set whether the <MASTER STROBE> button will toggle the master strobe or activate it only while the
button is pressed, follow the instructions below.
1. Press the <X> encoder to access the menu.
2. Turn the <X> encoder left or right to select Strobe.
3. Press the <X> encoder.
4. Turn the <X> encoder left or right to select from MOMENTARY (master strobe on while button is
pressed) or LATCH (button toggles master strobe).
5. Press the <X> encoder.
Presets Playback Mode
To set whether a selected preset will continue until manually stopped, or to set an interval at which the
presets will cycle, do the following:
1. Press the <X> encoder to access the menu.
2. Turn the <X> encoder left or right to select Presets.
3. Press the <X> encoder.
4. Turn the <X> encoder left or right to select from Static (selected preset will continue until manually
stopped) or Chase Play (presets will cycle, started with the selected preset).
5. Press the <X> encoder.
6. For Chase Play, turn the <X> encoder left or right to increase or decrease the cycle interval, from
1–20mintue (1–20 minutes).
7. Press the <X> encoder.
Power Loss
To select what connected products will do if the ILS Command loses power, follow the instructions below.
1. Press the <X> encoder to access the menu.
2. Turn the <X> encoder left or right to select Power Lost.
3. Press the <X> encoder.
4. Turn the <X> encoder left or right to select from BLACKOUT (blacks out all connected products),
LAST SET (continues the last instruction), or AUTO (all connected products switch to auto).
5. Press the <X> encoder.
To Next Page
Loading...
