7
Operation
ILS Command User Manual Rev. 1
Menu Map
Refer to the ILS Command product page on
www.chauvetdj.com
for the latest menu map.
Main Level Programming Levels Description
DFI Channel 1–16 Selects a D-Fi channel to transmit ILS
Back Light 6–100 Sets the level of the button back lights
Sound In
MIC Uses the built-in microphone for sound input
AUX Uses the 3.5 mm audio in for sound input
Sound Lost
HOLD Holds last instruction when no sound input
FREEZE Freezes on current output when no sound input
BLACK Blacks out all connected products when no sound input
Par Color
Tri Sets par control to tri-color RGB
Quad
Sets par control to quad-color RGBA (RGBW also
works)
Hex Sets par control to hex-color RGBAWUV
Program
Mode
SNAP Programs snap between colors
FADE Programs fade between colors
Effect Type
Spots
ON
OFF
Enables or disables selected effect types
Par
Laser
Strobe effect
Derby
GO BACK Returns to main level
Blinder
MOMENTARY Flashes blinders while <BLINDER> is pressed
LATCH Pressing <BLINDER> toggles blinders on and off
Strobe
MOMENTARY Products strobe while <MASTER STROBE> is pressed
LATCH
Pressing <MASTER STROBE> toggles strobing on and
off
Presets
Static Selected preset continues until manually stopped
Chase Play 1–20mintue Cycle through saved presets
Power Lost
BLACKOUT All products black out on ILS Command power loss
LAST SET
All products continue last instruction on ILS Command
power loss
AUTO All products switch to auto on ILS Command power loss
Laser Mode
OFF Disables lasers
EU Maintains EU laser standards
US Maintains US laser standards
USB Backup/
Restore
Backup Backs up presets and settings data via USB port
Restore Restores presets and settings data via USB port
Factory reset
WARNING!
This will permanently erase
all data. To continue, hold
BLACKOUT and PRESET4
for 5 seconds
Resets the ILS Command to factory defaults
CANCEL
System
Update
NO
Updates the ILS Command firmware via the USB port
YES
To Next Page
Loading...
