23
After connection, click [Rover Config], then set the rover’s differential format, antenna type
and other information, then click [finish ].
Data format: including CMR, RTCM3.X, RTD, SCMR(three constellations) and so on. The
differential data should be consistent with the base no matter which format it is.
Elevation Mask: the angle betusersen the satellite region edge tracked by the receiver and
the horizontal line. It means the receiver does not track satellites in this range. The mask
value is generally set to 13 degrees, but can be changed according to the satellite
distribution and the receiver’s operating region.
PDOP Limit: Position Dilution of Precision, which is attributed to the satellite geometry
distribution. The better the satellite distribution degree is, the higher the position accuracy
will be (smaller values represents higher accuracy). The default value is 6.
Safe Mode: including Normal Mode and Reliable Mode.
Iono Condition: including Quiet, Normal and Disturbed.
Antenna type: including A300, A100, X300, X90, X91 and so on. Click on the right of
Type column. Among those types, A300 and A100 are the external antennas of X60.
Measure to:including Bottom, Middle and Phase Center. It should be selected according to
antenna height.
To Next Page
Loading...
Need help?
General
