19
Users need to tick the little box in front of [Radio] to activate radio mode.
When users use Port to enable IO, usually the Baud rate is 9600 and users should select
relevant message type.
When users choose Auto Base, the mode is Auto Base. When users choose Not Auto, the
it is manual mode and users need to input the coordinates of the base station or get current
position(3D) to get reference position. Click [set], than configuration of IO is successful.
After finishing setting, users need to go back to break the Bluetooth connection if Bluetooth
is connected. Users don’t need to break connection if it’s WIFI connection.
Notice 1. If users use Bluetooth connection, users must break it. Otherwise, it will
bind the station by default after rebooting the base station, which will result in that the base
fails to transmit differential signals.
2.If the base is set to Auto Base, it will start working wherever connected to radio after the
boot without any other setting, which is convenient and efficient.
3.3 DL5-C Radio Setting
When operating in radio mode, users can use the on-off button on the radio panel to turn on
the radio, use channel switch button and pousersr switch button to set the pousersr and
frequency.
To Next Page
Loading...
Need help?
General
