CHC i80 User Guide

41
6.1.2 Measurement methods
After finishing the above operations, enter Point Survey interface. Click the diagram
and select Compensated Mode. Have the bottom of the centering rod aimed at the survey
point, tilt the centering rod(the tilt angle should be less than or equal to 30 degrees), then
click [Begin ]. The software will save the converted three-dimensional coordinates of
the correct point position.
If users want to use Auto Measure, just check the box in front of Auto Measure in [Survey
Option]. Any other operations refer to the guides.

CHC i80 Specifications

General

Brand	CHC
Model	i80
Category	Receiver
Language	English