–10 –
5.3 Zero adjustment of the measurement position
Each time the measurement position is changed, the tension meter will automatically
perform a zero adjustment.
If the tension meter does not display zero in its measuring position, perform a manual
zero adjustment procedure. For this purpose, no material to be measured must have been
inserted yet!
Requirements:
1. The tension meter has been switched on as described in Section 3.2.
To carry out zero adjustment:
1. Bring the tension meter into the desired measuring position and make sure not to
move it.
2. Press the button.
The DISPLAY momentarily shows and then switches to
The tension meter is now adjusted to its new measuring position and ready to take
measurements.
5.4 Inserting and removing the material to be measured
Material to
be measured
Filament guide
Measuring
roller
Thumbpiece
Guide rollers Guide rollers
Thumbpiece positions
Pos. 1Pos. 2 Pos. 0
2 = Measurement position
0 = Adjustment position
1 = Thread in position
(the guide rollers
extend forward)
1
2
To Next Page
Loading...
Need help?
General
