Check-line DTS-200 - Memory Functions; Save Data; Displaying the Saved Measured Values; Deleting the Saved Measured Values

– 19 –
6.3 Memory functions
You can store and display the statistics of one measuring series (last measured value,
the average, the minimum and maximum measured values, the peaks, the standard
deviation).
Data is recorded during a user-dened period.
6.4 Save data
1. Press the button to start recording the measured values.
2. While recording is in process, “Rec S” ashes on the display.
3. Press the button again to stop recording.
4. To save the recorded data, press the button (the display shows “Mem S”).
Data, stored in the memory before, will be overwritten.
5. Press the button to stop recording the measured values
without saving
NOTE: To abort data recording, press the button. This stops
the procedure. No data will be saved.
6.5 Displaying the saved measured values
1. Press the Recall and buttons simultaneously to display the saved data.
6.6 Deleting the saved measured values
If data is saved in the tension meter, the display shows “Mem” .
Deleting data:
1. Press the Recall and buttons
2. Then press the button and conrm with the button.
This clears the memory.
The display will only show statistical values
Name of the material to be measured MIN.
Date and time of the measurement series PEAK max.
Last reading PEAK min.
Average Standard deviation (Std. Dev.)
MAX. Number of measured values
FIG. 15