Check-line DTS-200 - Default Chapter; Table of Contents

–1 –
TABLE OF CONTENTS
1.0 Introduction ................................................................................................................. 02
2.0 Overview of Operating And Display Elements .......................................................... 03
3.0 Set-up ...................................................................................................................... 06
3.1 Charging the battery
3.2 Turning the tension meter ON and OFF
4.0 Tension Meter Settings ............................................................................................... 07
4.1 Procedure
4.2 Setting chart
4.3 Material menu
4.4 Password
4.5 Factory Reset
5.0 Operation .................................................................................................................... 10
5.1 Requirements
5.2 Material thickness compensator
5.3 Zero adjustment of the measurement position
5.4 Inserting and removing the maaterial to be measured
5.5 Damping
5.6 ALARM function
5.7 Cal. adjustment
5.8 Peak Value
6.0 Creating a Material Characteristic .............................................................................. 16
6.1 Calibration procedure
6.2 Verifying the calibration
6.3 Memory functions
6.4 Save data
6.5 Displaying the saved measured values
6.6 Deleting the saved measured values
7.0 Specications ............................................................................................................. 21
7.1 General specications
7.2 Available models
7.3 Guide rollers
8.0 Maintenance and Cleaning ............................................................................................ 23
8.1 Maintenance
8.2 Cleaning
9.0 Warranty...................................................................................................................... 24
WARNING: Tensions that exceed the tension range of the instrument by more
than 100% may cause permanent damage to the measuring spring and must be
avoided under any circumstances.