– 20 –
Calibration According factory procedure
Accuracy For PA from 5 % up to 100 % full scale:
± 0.5 % full scale ± 1 digit
remaining tension range and other calibration materials:
± 3 % FS* ± 1 digit
Memory for material
curves 1 factory calibration plus 4 for customized calibrations
Measuring units Force (switchable): cN, daN, g, kg, N, lb
Thickness (switchable): mm, inch
Overrange Approx. 10 % full scale, full scale, without accuracy guarantee
Overload protection 100% full scale
Measuring principle Strain guage bridge
Measuring roller
deection Max. 0.2mm
Signal processing Digital
Measuring frequency Max. 1 kHz (1000 measuements/sec.), internal 8 kHz
Display Graphic LCD display
3 different displays: numeric, numeric with bargraph,
X-Y-diagramm (time-tension)
Display update time 2/sec (Display update)
Memory MIN, MAX, PEAK, AVG and LAST
Damping Adjustable electronic damping (averaging)
Cal. adjustment ± 10 steps in 1% increments
Thickness compensation Max. 2.5 mm (not available for all models)
Auto power off Approx. 3 minutes of non-use
Signal processing 16 bit A/D
Temperature coefficient Gain: less than ± 0.01 % full scale* /°C at 25° C
Zero point: better than ± 0.3 % full scale* /°C at 25° C
Temperature range 10 to 45° C
7.0 SPECIFICATIONS
7.1 General Specifications
Continued on next page
To Next Page
Loading...
Need help?
General
