Check Point 2200 - Configuring 2200 Appliance; Powering on; Available Software Images

Configuring 2200 Appliance
14 | Check Point 2200 Appliance Getting Started Guide
Chapter 2
Configuring 2200 Appliance
In This Chapter
Powering On 14
Available Software Images 14
Initial Configuration 15
Using the First Time Configuration Wizard on Gaia 15
Using the First Time Configuration Wizard on SecurePlatform 20
Creating the Network Object 24
Advanced Configuration 24
The workflow for configuring 2200 Appliance is:
1. Mount the 2200 Appliance in the rack.
2. Connect the cables and power on.
3. Perform the initial configuration.
4. Add the 2200 Appliance object in SmartDashboard and install a policy.
Powering On
To power on 2200 Appliance:
1. Connect the power adapter cables to the appliance and the power source.
2. From the back panel, power on the appliance.
Wait for the appliance to initialize and boot.
Available Software Images
The 2200 Appliance comes with two software images. Choose the software image you want to
use.
Reverting to a different software image takes a few minutes. To follow progress and see when
the appliance is ready, connect to the appliance using a serial console.