Configuring 2200 Appliance
Check Point 2200 Appliance Getting Started Guide | 15
For more about software images, see the 2200 Appliance home page
(http://supportcontent.checkpoint.com/solutions?id=sk68680).
Note - Gaia is available for R75.40 and higher.
Initial Configuration
Do the initial configuration of the appliance with the First Time Configuration Wizard.
There are different First Time Configuration Wizard options for the Gaia and the
SecurePlatform operating system.
Go to the applicable section:
Using the First Time Configuration Wizard on Gaia (on page 15)
Using the First Time Configuration Wizard on SecurePlatform (on page 20)
Using the First Time Configuration Wizard on Gaia
Use the First Time Configuration Wizard to do the initial configuration of the Gaia appliance.
Note - The pages that you see in the wizard depend on the software image and the
options you select. You will not see all the pages that are in this section.
Starting the Gaia First Time Configuration Wizard
To start the First Time Configuration Wizard:
1. Connect a standard network cable to the appliance management interface and to your
management network.
The management interface is marked MGMT. This interface is preconfigured with the IP
address 192.168.1.1.
2. Connect to the management interface from a computer on the same network subnet.
For example: IP address 192.168.1.x and net mask 255.255.255.0. This can be
changed in the WebUI, after you complete the First Time Configuration Wizard.
3. To access the management interface, open a connection from a browser to the default
management IP address: https://192.168.1.1
4. The login page opens. Log in to the system using the default username and password:
admin and admin
5. Click Login.
Note - The features configured in the First Time Configuration Wizard are
accessible after completing the wizard using the WebUI menu. The WebUI menu
can be accessed by navigating to https://<appliance_ip_address>.
To Next Page
Loading...
