6000 and 7000 Appliances Installing and Removing Memory
6000 and 7000 Appliances Replacing Memory|6
To prepare the appliance:
1.
Shut down the appliance from the WebUI, CLI, or by pressing and releasing the power
switch quickly.
Note that pressing and holding the power switch is not recommended as it results in a
forced and immediate shut down.
2.
Remove the power cords from the appliance.
3.
Put on the ESD strap and attach the other end:
n On 6500 appliances - To any unpainted point on the appliance chassis.
n On 6200, 6400, 6600, 6700, 6800, 6900, and 7000 appliances - To the ESD grounding
plug on the rear panel of the appliance.
4.
Loosen the appliance cover screws.
5.
Remove the top cover from the appliance.
To remove the top cover:
1.
Unscrew the cover screws (number 2 below).
2.
Pull the top cover back in the direction of the arrows.
3.
Pull the cover up to remove it completely.
The 6800 appliance is shown above. Removal of the top cover is the similar for all 6000
appliances.
To Next Page
Loading...
