Check Point 6700 - Verifying Memory Configuration; Using CLI Command for Verification

6000 and 7000 Appliances Installing and Removing Memory
6000 and 7000 Appliances Replacing Memory|26
Verifying the Memory Configuration
1.
In the CLI, enter Expert mode.
2.
Run: # free -g -o
Example for a 6500 appliance with 16 GB of memory:
[Expert@gw-419463:0]# free -g -o
total used free shared buffers
cached
Mem: 15 0 15 0 0
0
Swap: 16 0 16
Note - The amount of installed memory is shown in the row named Mem under
the column named total.
For reasons related to available memory address space, the total installed
memory shown in the freeutility is similar but not identical to the actual
installed memory.
In the above example, 16 GB of RAM are installed on the system. This corresponds to the 15 GB of
total memory shown in the freeutility.