Check Point QS-2 - Using the Power Cable Restraint Strip on 6200 and 6400 Appliances

6000/7000 Appliances Hardware
6000 and 7000 Appliances Getting Started Guide|42
Using the Power Cable Restraint Strip on 6200 and
6400 Appliances
On 6200 and 6400 appliances, you can use the power cable restraint to prevent accidental
removal of the power cable.
Item Description
1 Restraint anchor
2 Cable loop
3 Restraint strip tab
4 Restraint strip
To install the power cable restraint strip:
1.
If a power cable is connected to the power supply inlet, disconnect it.
2.
Unscrew the screw directly above the power supply inlet.
3.
Make sure the cable loop on the restraint strip faces the power supply inlet.
4.
Insert the restraint strip anchor into the slot and screw it in until it locks.