Check Point QS-2 - Using the Restraint Clip on 6500, 6600, 6700, 6800, 6900, and 7000 Appliances

6000/7000 Appliances Hardware
6000 and 7000 Appliances Getting Started Guide|43
5.
Connect the power cable to the power supply inlet.
6.
Move the cable loop on the restraint strip.
7.
Move the cable loop until you can put it around the power cable.
8.
Insert the open side of the cable loop into the loop slot until it is tight against the power
cable.
9.
Make sure the cable loop is secured and the power cable cannot be removed.
Using the Restraint Clip on 6500, 6600, 6700, 6800,
6900, and 7000 Appliances
The 6500, 6600, 6700, 6800, 6900, and 7000 appliances have a power cable restraint clip attached
to the power supply unit (PSU). Use the restraint clip to prevent accidental removal of the power
cable.
To secure the restraint clip on the power supply cable:
1.
Make sure the restraint clip is in the open position (upward).
2.
Connect the power supply cable to the power supply inlet on the PSU.