Check Point QUANTUM FORCE 19000 - Mounting the Appliances in a Rack; Appliance Specifications; Appliance Air Vents

Mounting the Appliances in a Rack
Quantum Force 19000 and 29000 Appliances Getting Started Guide|35
Mounting the Appliances in a Rack
You can install your 19200 / 29100 / 29200 Appliance with the Telescopic Rails hardware. See
Rack Mounting for Check Point Appliances for the procedure.
Appliance Specifications
Applianc
e
Regulate
d Model
Width Depth Height U
Maximum
Operating
Temperatur
e
PSU
Electrical
Specification
s
19200
RR1-CP-
25
17.40
in
(44.2
cm)
24.01
in
(61.0
cm)
3.46 in
(8.8
cm)
2U
32°F - 104°F
0°C - 40°C
From 100V
(10A)
to 240V (5A),
47 - 63Hz
29100
RR1-CP-
10
17.40
in
(44.2
cm)
24.01
in
(61.0
cm)
3.46 in
(8.8
cm)
2U
32°F - 104°F
0°C - 40°C
From 100V
(13.8A)
to 240V
(8.5A),
47 - 63Hz
29200
RR1-CP-
20
17.40
in
(44.2
cm)
24.01
in
(61.0
cm)
3.46 in
(8.8
cm)
2U
32°F - 104°F
0°C - 40°C
From 100V
(13.8A)
to 240V
(8.5A),
47 - 63Hz
Appliance Air Vents
When the appliance is mounted in a rack, make sure that the appliance air vents have
sufficient airflow from front to rear.
Important - If the appliance vents are blocked, the appliance can become too hot and
be damaged.
The appliance and rack rails were tested in extreme conditions and when properly installed do
not block air flow to the appliance.
These appliances are specifically designed to install with these rails.